Carbon Fiber Parts for BMW S1000RR — Replicate Any Part in 2–5 Weeks
Carbon fiber replication for the BMW S1000RR — intakes, tank cover, skirts, swingarm covers and wing attachments. Factory fit, mould retained.
Carbon fiber parts for your BMW S1000RR
The BMW S1000RR is a track-day favourite in the UAE, and we've replicated full carbon sets for it — including the intakes, fuel tank cover, lower skirts, swingarm covers and wing attachments. Each panel is moulded from your original for exact fitment.
We use 2×2 twill for the visible bodywork and a carbon + Kevlar hybrid for high-abrasion parts like swingarm covers. High-temp epoxy is specified for intake and tank-facing panels that sit in the engine's heat.
Most-replicated BMW S1000RR parts
Bring Us Your Part
The workflow is simple: you bring the original part, we replicate it in carbon fiber, and we keep the mould. Because the mould stays with us, the tooling cost is spread across future reorders — you effectively pay only a share of the mould up front, and nothing for it again.
Bring us your original part
Drop your BMW S1000RR part at our Ras Al Khor workshop, or ship it to us. Not sure it's replicable? Send a photo on WhatsApp first.
We replicate it in carbon fiber
We mould from your original across every face needed to capture the geometry, then hand-lay carbon fiber and finish it with a UV-stable clear coat.
You get the part back — factory fit
Your carbon copy fits exactly like the original: same dimensions, same mounting points, lighter and stronger. Typical turnaround is 2–5 weeks.
We keep the mould for reorders
The mould stays with us. Want a matching set, a second car, or a replacement after track damage? You only pay for the part next time — never the tooling again.
Materials & Specifications
Clear coats and resins are matched to the part's job and the Gulf climate. Here's the honest heat resistance you can expect from each system:
Standard UV clear coat
UV-stabilized finish for everyday interior and exterior parts.
Premium UV clear coat
Upcharge. Higher heat tolerance for engine bays and sun-exposed panels.
Standard epoxy
Our default laminating resin — strong, stable, UAE-tested.
High-temp epoxy
Special order — contact us. For extreme under-hood and exhaust-adjacent parts.
Not sure which system your part needs? Send us the application on WhatsApp and we'll spec the right clear coat and resin.
BMW S1000RR carbon fiber — FAQ
Can you replicate a full S1000RR carbon bodywork set?
What weave do you use for the swingarm covers?
Do you keep the mould for reorders?
Have a BMW S1000RR part to replicate?
Send a photo on WhatsApp and we'll tell you if it's replicable — usually within hours.
WhatsApp +971 56 900 0407